
CHAPTER 2: NETWORK SETUP SET UP THE NETWORK FOR AUTHENTICATION
8E6 TECHNOLOGIES, R3000 INTERNET FILTER AUTHENTICATION USER GUIDE 37
3. In the Block Page Device frame:
• If using the invisible mode, select “LAN2”.
• If using the router or firewall mode, select “LAN1”.
If using the invisible mode, the Block Page Delivery
Method frame displays. Choose from either of the two
Protocol Methods:
• “Send Block Page via ARP Table” - this option uses the
Address Resolution Protocol method to find the best
possible destination MAC address of a specified host,
usually the R3000 gateway.
• “Send Block to Specified Host MAC Address” - using
this preferred method, the block page will always be
sent to the MAC address of a specified host, usually
the R3000 gateway.
Choose from either of the two Block Page Route To
selections:
• “Default Gateway” - this option indicates that the
default gateway on your network will be used for
sending block pages.
• “Alternate IP Address” - this option should be used
if block pages are not being served.
Enter the IP address of the router or device that will
serve block pages.
4. Click Apply.
Comentarios a estos manuales