8e6 Technologies Threat Analysis Reporter TAR Manual de usuario descargar pdf (Pagina 72)

68 8e6 ThreaT analysis reporTer Quick sTarT Guide

Tap insTallaTion

Install the Ethernet Tap Unit

Diagram showing TAR Ethernet Tap installation on the network

This step is a continuation from Physically Connect the Unit to the Network in Step 1A

or following setup in Step 1B. The procedures outlined in this step require the use of a

CAT-5E cable.

A. Provide power to the Ethernet Tap by connecting both power cords from the unit to

the power source.

AC power in rear panel of NetOptics 10/100BaseT Tap

B. If a designated source R3000 (to be used with the Threat Analysis Reporter) is al-

ready installed on the network, disconnect the cable that connects this R3000 to the

switch.

If the designated R3000 has not yet been installed, disregard this sub-step and pro-

ceed to sub-step C.

1 2 ... 67 68 69 70 71 72 73 74 75 76

Sin comentarios

8e6 Technologies Threat Analysis Reporter TAR Manual de usuario Pagina 72